Wheeler Nylon/Brass Hammer - Gunsmithing Bench Hammer brand_-ButlerCreek

Wheeler Nylon/Brass Hammer - Gunsmithing Bench Hammer brand_-ButlerCreekThe Wheeler Nylon Brass Hammer is a dual face gunsmithing hammer built to earn a permanent spot on the bench. One face is nylon, which is non marring and well suited to alignment work and any job where a steel hammer risks damaging the part. The other face is brass, ideal for driving pins and punches without deforming their heads or marking surrounding metal. At 11in overall and weighing 8oz, it strikes a good balance between reach and control, giving

These are Lapua

A genuine piece of British calling heritage

An incredibly lightweight

lifting the sight line by 13mm to clear high objective lenses or improve cheek-weld alignment

Scope cant — the lateral tilt of a rifle as it rests in the shoulder — introduces windage errors that compound rapidly with distance

at the end of a stalk

can be run together or independently and reconfigured into more than a dozen positions

Up front there are two pleated chest pockets with buttoned flaps plus a separate zipped pocket that keeps a licence

The small hollow-point meplat trims the frontal area to reduce drag

it slips into a jacket pocket without notice

no special equipment is needed

rats and mice