500k Push/Push Pot with US Specs Guitar Pot Kits

500k Push/Push Pot with US Specs Guitar Pot Kits500K ohm log (audio taper) pot with push push actuator switch. For humbucker pick ups. For coil tapping, splitting, phasing. Brass 3 8" bushing. Will accept US push fit knobs (not metric). 20% tolerance + Comes complete with 2 fixing nuts and washer. 9mm thread diameter 9mm length of threaded shaft 26mm depth under scratchplate (without threaded portion) 47mm total pot depth

with a 45 degree bevelled edge

They will not fit the Nashville-style of Tune-O-Matic bridge or an original 50's or 60's ABR-1 that were fitted to a Kalamazoo-made Gibson guitar

Height = 41/64 in

allowing for quick and secure clamping of the guitar strings inside the tuner post

This is a very limited edition Kent Armstrong set of two humbucking pickups

Each plate mounts with 5 screws

Comes fitted with slot-adjusted tightening grub screw to secure to pot shaft

05 µF - 50VDC

393 N/A Approx In 2 13/16 1/8 13/32 N/A Millimeters

Magnet Length = 57mm length x 5mm thick x 7mm wide

End to End mounting holes are 5 29/32 inches apart

Outer measurements - 91mm x 40