LINK Ballast Resistor (BAL4) LINK Sensor

LINK Ballast Resistor (BAL4) LINK SensorFor use with low impedance injectors. Compatible with injectors with impedance between 2 and 6 Ohms. Please contact us if you are planning on using injectors with an impedance of less than 2 ohms. Includes set of 4 x 4. 7ohm 25w resistors mounted to a heatsink. These are also sold in a set of 6. Note that injector ballast resistors get quite hot at high injector duty cycles. These should stay mounted on the supplied heat sink and be bolted to the

Requires HEI-type plug wire ends/ boots

All Link G4+ and G4X Plugin ECUs

Seal locating tab

Includes set of 6 x 4

Mounting bracket for G4+ & G4X Fury

This sensor also measures fuel temperature

2 meter CAN Extension Cable for increased reach between your ECU CAN cable and CAN splitter/s or CAN device/s

This means that it is suitable for turbo or supercharged applications running up to 2

if you’ve used one before you know how tricky it is to make up a cradle to mount it

1 x Mating Connector Kit

1x 4 Pin Housing

AN-8 ORB outlets on each end of the fuel log