Flap Discs 60 Grit Angle Grinder 4.5" (115mm) Flat Sanding Grinding Gear & Bearing Pullers

Flap Discs 60 Grit Angle Grinder 4.5" (115mm) Flat Sanding Grinding Gear & Bearing PullersFor use with 4. 5" (115mm) angle grinders and sanders when removing rust, grinding of welds, parting lines on casting and carbon steels or removing rough edges on most surfaces. The High grain adhesion is for a long life which outlasts conventional sanding discs, with these flap discs there is no backing disc required, it fits directly onto an angle grinder and with different grits of discs you'll be able to finish your job a lot quicker than any

This listing is for a pair (left and right) of galvanised suspension units with 4" PCD hubs

1 X Allen Key

It is much safer than a traditional tow rope as it prevents the vehicle that is being towed running into the one in front

• Detachable handle

- 4 x wheel nuts / studs

With them not being twisted wire brushes

Small head profile

Oars can be easily angled if necessary

1 x 1/4" drive socket rail total length 400mm / total number of clips 14

Total length 50cm closed

1/2 drive so will fit any 1/2" ratchet

1/4 x 20 BSW