Bando TL60-S14M-80 STS TL Timing Belt Pulley (4030) TERMINAL BLOCKS ACCESSORIESBando TL60 S14M 80 The type of pulley used on a Synchro Link drive depends on a number of factors, including but not limited to, space available, ratios, center distances, horsepower being transmitted, speeds and user preference of mounting systems (i. e. QD, TL or Minimum Plain Bore). With Synchro Link Drives, as with gear or chain drives, circular pitch (usually referred to as pitch) is a fundamental consideration. On the belt, pitch is the distance
25 MOTOR TYPE FHP AMBIENT 40 ROTATION CCW LEAD END SERVICE FACTOR 1 RUNCAPMFD 6 RUNCAPVOLTS 370 SHIPPING WEIGHT 19 BREAKDOWN TORQUE 22
9x(Code E) No load current 9
0 SERVICE FACTOR AMPS PRIMARY 24
Amperes 133/66
10 A Rated torque 54
Standard NEMA MG-1 Frame 184TC Frequency 60 Hz Number of poles 4 Degree of Protection IP56 Synchronous speed 1800 rpm Mounting F-1 Flange C Terminal box¹ Left position Enclosure TEFC Attributes
3 POLES 4 NUMBER SPEEDS 1 RPM 1700 HERTZ 60 VOLTS PRIMARY 115/230 V VOLTS 115 VOLTS 2 230 FRME 48 SHAFT CODE Z STATOR DIAMETER 5
Standard NEMA MG-1 Frequency 60//50 Hz Voltage 230/460//190-220/380-415 V Number of poles 6 Degree of Protection IP55 Synchronous speed 1200 rpm Output rating 3 HP Mounting F-1 Flange Without Terminal box¹ Left position Enclosure IC411 - TEFC
Standard NEMA MG-1 Frequency 60 Hz Voltage 460//380-415 V Number of poles 6 Degree of Protection IP55 Synchronous speed 1200 rpm Output rating 40 HP Mounting B3L(E) Flange Without Terminal box¹ Right position Enclosure IC411 - TEFC
Bando - TL4030 1 3/4 TL® bushings are preferred where mounting space is at a premium
875 IN Shaft Extension Location Pulley End Shaft Ground Indicator No Shaft Grounding Shaft Rotation Reversible Shaft Slinger Indicator No Slinger Speed 1765 rpm Speed Code Single Speed Motor Standards NEMA Starting Method Direct on line Thermal Device - Bearing None Thermal Device - Winding None Vibration Sensor Indicator No Vibration Sensor Winding Thermal 1 None Winding Thermal 2 None XP Temp Code T4 Drawings
00 % Rated voltage 415 V Rated current 5
