OTR Roxor Intake Hold Down banksThis is On the Rox Fabrications intake hold down for the Mahindra Roxor. Because of the factorys flawed Roxor intake design, the intake boot can begin to leak under hard boosting. This can cause a variety of problems, most noticeably a loss of power. This can happen at any power level, whether your unit still has the factory tune or not. This intake hold down helps to keep the factory intake planted even under extreme boosting scenarios. After many
A simple 1/8” NPT pressure connection requires no electrical hookup for operation
The Roxor Lo Pro Top 2 Seater is a high-quality aftermarket accessory designed for the Mahindra Roxor off-road vehicle
LLC is not affiliated with Caterpillar or the Caterpillar brand
We have been using these starters for about 14 months now and haven't had a failure yet These will work on any Manual Trans Roxor from 2018 to current year models The Roxor Aftermarket Starter is a high-quality replacement part designed specifically for the Mahindra Roxor off-road vehicle
Daisy chain up to 6 Thermocouple Modules and 6 Analog Sensor Modules per system allowing you to add over 48 new sensors to your Banks iDash 1
TIRE WHEEL BACKSPACING OFFSET 35x12
then validated through extensive temperature testing in all areas: before and after the DPF
5 - 2024 Cummins ISX15 & X15 Engines
Gauge Size: 2-1/16 inch (52mm) diameter
The additive not only aids in easy engine start-up but also enhances fuel stability
Includes all necessary hardware
ensuring improved safety and control on rough terrains
