Adafruit Motor/Stepper/Servo Shield for Arduino v2.3 Kit Robotics

Adafruit Motor/Stepper/Servo Shield for Arduino v2.3 Kit RoboticsThis kit has TB6612 MOSFET drivers with 1. 2A per channel current capability (you can draw up to 3A peak for approx 20ms at a time). It also has much lower voltage drops across the motor so you get more torque out of your batteries, and there are built in flyback diodes as well. Instead of using a latch and the Arduino's PWM pins, this kit has a fully dedicated PWM driver chip onboard. This chip handles all the motor and speed controls over I2C. Only

mono Wave (

This is a box of ten 25ft spools of solid-core wire

breadboard-friendly breakout

we don't recommend it for use with any other protocol or voltages

which can snap onto the Pi PCB (and is removable later if you wish) and gives you all sorts of prototyping goodness to make building on top of the Pi easy

No soldering required

or solder wires directly

you can control an infinite number of LEDs

With BLE now included in modern smart phones and tablets

Conventional subwoofers are traditionally considered optimized when you can feel rather than hear the bass

White and all off

So the LSM9DS0 has ±2 gauss low range where-as the LSM9DS1 has ±16 gauss high range