PiJuice - Short Case NeoPixels

PiJuice - Short Case NeoPixelsThe case features a sliding lid allowing for easy access to the PiJuice HAT and battery. Small openings on the side will give you access to the three buttons and two RGB LEDs on the PiJuice so you can stay in control of your project. Case Features Compatible with the Raspberry Pi 3, 2, and B+. The Raspberry Pi A+ will also fit inside but may slide around a little No tools are necessary for assembly or disassembly 4 x rubber feet included Access to

this SIK does NOT include a carrying case or print guidebook

where you will be prompted to enter the serial number from the case of your iMM-6

You can set the color of each LED's red

The Teensy LC comes pre-flashed with a bootloader so you can program it using the on-board USB connection: No external programmer needed

available in any office or stationery supply store

Pi Zero and speakers not included

This version adds an SMD ISP header for use with shields

which communicates with one Fadecandy board or dozens

Because they have a genuine JST connector

unencrypted radio signals

Instead of using a latch and the Arduino's PWM pins

the FONA is intended for hackers and advanced makers