Bando 860H200G H Timing Belt Hazardous Location NEMA C FaceBando 860H200G The extra durable, highly flexible neoprene backing provides excellent abrasion and wear resistance especially important if power is transmitted from the back of the belt. Backing also guards the tensile cords against oil, grease, dirt, and moisture. Continuous, helically wound high strength fiberglass tensile cords guarantee dimensional stability to eliminate take up adjustments. Heavy torque loads wont fatigue this super strong cord.
0 V @ 60 HZ Agency Approvals CCSA US Auxillary Box No Auxillary Box Base Indicator Rigid Bearing Grease Type Polyrex EM (-20F +300F) Current @ Voltage 32
75 kW) Number of Poles 2 Frequency 50 Hz Rated speed 2770 rpm Slip 7
Rheem51-21833-01
Bando - 210-S8M-1424 HP Anticipating the demand for energy savings and higher horsepower transmission
Catalog Number CEM3156T-G Enclosure OPSB Frame 145TC Frame Material Steel Frequency 60
8 a Front Face Code Standard Front Shaft Indicator None Heater Indicator No Heater Insulation Class H Inverter Code Inverter Ready KVA Code M Lifting Lugs No Lifting Lugs Locked Bearing Indicator Locked Bearing Motor Finish UNPAINTED Motor Lead Exit Ko Box Motor Lead Termination Flying Leads Motor Lead Quantity/Wire Size @ AWG 9 @ AWG Motor Type 3532M Mounting Arrangement F1 Number of Poles 2 Overall Length 13
Bando - SK 3/4 The original sheave and pulley mounting system developed to facilitate installation and replacement of components
Amperes 1822 A LRC 6
Bando - P30-8M-20 The type of pulley used on a Synchro-Link® drive depends on a number of factors
625 IN Shaft Ground Indicator No Shaft Grounding Shaft Rotation Reversible Shaft Slinger Indicator No Slinger Speed 1415 rpm Speed Code Single Speed Motor Standards NEMA Starting Method Direct on line Thermal Device - Bearing None Thermal Device - Winding None Vibration Sensor Indicator No Vibration Sensor Winding Thermal 1 None Winding Thermal 2 None Drawings
Degree of Protection IP55 Enclosure IC411 - TEFC Mounting F-1 Rotation¹ Both (CW and CCW) Noise level² 46
7 POLES 2 NUMBER SPEEDS 1 RPM 3526 HERTZ 60 VOLTS PRIMARY 575 VOLTS 575 FRME 184 SHAFT CODE T MOUNTING HORZ-FOOTED ASSEMBLY POSITION F1 MOTOR TYPE CE OPPOSITE END BEARING 6206-J/C3 SHAFT END BEARING 6206-J/C3 AMBIENT 40 ROTATION DUAL SERVICE FACTOR 1
