BMW N54 Intercooler Kit BMW-530e-2018

BMW N54 Intercooler Kit BMW-530e-2018The OEM intercooler is made from plastic end tanks that are crimped on to an aluminum tube fin core that is ~4 inches thick (105mm core width) and is 5 inches in height (127mm). This may be enough to keep IAT in check on a completely unmodified stock vehicle, but once users to start increase power through bolt on modifications, tuning, and built engines, the OEM intercooler will become the Achilles heel of the system with IAT skyrocketing out of the

Steve Dinan has been building BMW race engines for over 40 years

Fuel Measurement Condition Horsepower Torque (lb-ft) 93 Octane Calculated Flywheel OEM Stock 528 476 Tuned 701 623 Measured Wheel OEM Stock 465 419 Tuned 617 549 100 Octane Calculated Flywheel Tuned 715 632 Measured Wheel Tuned 630 557 *This can ONLY be installed at an Authorized CarBahn dealer

Not An Open-Intake Gimmick

The goal of a valve spring pressure is to make it as low as possible

000 miles (80

Seamless Fit: Engineered for a direct fit

Gloss Black

Triple-pass flow design

font-size:clamp(17px

Stage 1 Power package Includes:  1 - ST - 2 Software

system-card h4{ margin: 1

Superior filtration for maximum protection